On my 13700k with thermalright contact frame, and Arctic Liquid Cooler II 360mm AIO, thermal grizzly paste, despite the contact frame which helped reduce the temps of all cores, P5 is still 15-20C higher than most of the other P cores. In XTU P4 and P5 are starred, so are the best performing onces. I undervolt by 0.115V. The “chips” rating by my Z790 Elite AX gigabyte motherboard is 93. Finally, I pipe in cold outside Canadian air to blow on open PC.

Any suggestions on what I can do to improve this? Or is this “Normal” All other posts I’ve read suggest this isn’t normal.

Current temps on full load: P0 68C P1 71C P2 67C P3 85C P4 70C P5 91C P6 69C P7 78C. The E cores are all 62-64C. Clocks on full load: 5.3GHz all P cores. Power 195W Vcore 1.164V.

  • fediverser@alien.topEnglish
    1·
    11 months ago

    This post is an automated archive from a submission made on /r/intel, powered by Fediverser software running on alien.top. Responses to this submission will not be seen by the original author until they claim ownership of their alien.top account. Please consider reaching out to them let them know about this post and help them migrate to Lemmy.

    Lemmy users: you are still very much encouraged to participate in the discussion. There are still many other subscribers on !intel@hardware.watch that can benefit from your contribution and join in the conversation.

    Reddit users: you can also join the fediverse right away by getting by visiting https://portal.alien.top. If you are looking for a Reddit alternative made for and by an independent community, check out Fediverser.

  • SkillYourself@alien.topBEnglish
    1·
    11 months ago

    P3, P5, P7 are all on one side of the CPU, so it’s likely the cooler pressure on the CPU IHS isn’t even for some reason.

    Some ideas:

    1. Use more paste and make sure the paste imprint is even.

    2. Double check to make sure you didn’t mix the LGA1200/1700 standoffs which are different lengths.

    3. Make sure the excessively large universal Arctic mounting frame isn’t catching on a VRM component.

    4. Make sure the contact frame tension is even across all four screws

  • accord1999@alien.topBEnglish
    1·
    11 months ago

    Current temps on full load: P0 68C P1 71C P2 67C P3 85C P4 70C P5 91C P6 69C P7 78C. The E cores are all 62-64C. Clocks on full load: 5.3GHz all P cores. Power 195W Vcore 1.164V.

    With that large temperature delta between most P-Cores and the two hot ones, my suggestion is to take a closer look at how the thermal paste is distributed over the CPU surface and see if the “pump-out” effect has caused the paste to be too thin in the middle .