I’m trying to turn my first bike into a bobber style bike. I need a new gas can, seat, exhaust, and headlight. I’m new to the bike building world so any help will be very much appreciated! (Picture is of the current situation)
I would be rid of those floorboards personally, then head over to lowbrow customs and find some nice pieces
You got a website perchance? I’m taking the floorboards out Sunday same as a whole bunch of things!
https://www.lowbrowcustoms.com/
I got lots of my parts from here for my virago bobber/chopper
Bobbed bike: strip off all non-essentials or legally required.
After that step, re-evaluate the legally required bit.
A lot of people put on peanut tanks and spring seat, and cut the rear fender in half. In reality, you can bob a bike without spending a single dollar, as it’s literally removing from and not adding to the bike.
I also should mention I have no fenders. I have shitty seat and a cracked gas can
I used a stock front fender turned around and cut short on my roadstar build. Check my post history for pics. It turned out really well, in my opinion.
What’s a good way to clean the frame and engine?
Unless you’re pulling it out, I wouldn’t bother, but engine degreaser is great, brake clean works well but a law recently passed and chlorine is no longer in it, or much less? I don’t remember, making it a lot worse than it used to be
Makes sense! I restore classic cars for my job and was gonna bring the bike to bike shows for work. I’ll probably haul it to work and pull the engine out and clean it!
So it looks like you have a split backbone frame. Peanut tank is going to be tough for this but… if you find shorter air filters you could get away with a flat bottom peanut tank for like an 06 Honda shadow. Seat looks like an easier one to tackle. Bolt the bracket to that threaded hole and weld on the spring brackets to thwart cross beam.