In my home network, I’m currently hosting a public facing service and a number of private services (on their own subdomain resolved on my local DNS), all behind a reverse proxy acting as a “bouncer” that serves the public service on a subdomain on a port forward.
I am in the process of moving the network behind a hardware firewall and separating the network out and would like to move the reverse proxy into its own VLAN (DMZ). My initial plan was to host reverse proxy + authentication service in a VM in the DMZ, with firewall allow rules only port 80 to the services on my LAN and everything else blocked.
On closer look, this now seems like a single point of failure that could expose private services if something goes wrong with the reverse proxy. Alternatively, I could have a reverse proxy in the DMZ only for the public service and another reverse proxy on the LAN for internal services.
What is everyone doing in this situation? What are best practices? Thanks a bunch, as always!
You must log in or register to comment.
Alternatively, I could have a reverse proxy in the DMZ only for the public service and another reverse proxy on the LAN for internal services.
I do exactly this now. Public facing services sit in a dmz vlan with a rev proxy. I almost did a 2 tiered dmz but decided it was overkill.
Private services sit on an inside vlan.
If you are running your servies in a single VM in your DMZ then that is your point of failure. You could spin up 2 micro VMs and run something like Docker swarm to make sure there are 2 trafik proxies running.
The services run on a separate box; yet to be decided on which VLAN I put it. I was not planning to have it in the DMZ but to create ingress firewall rules from the DMZ.
Double NIC on the proxy. One in each VLAN.
One proxy with two NICs downstream? Does that solve the “single point of failure” risk or am I being overly cautious?
Plus, the internal and external services are running on the same box. Is that where my real problem lies?
Are you running redundant routers, connections, ISPs…etc? Compromise is part of the design process. If you have resiliency requirements redundancy will help, but it ratchets up complexity and cost.
Security has the same kinds of compromises. I prefer to build security from the network up, leveraging tools like VLANs to start building the moat. Realistically, your reverse proxy is likely battle tested if it’s configured correctly and updated. It’ll probably be the most secure component in your stack. If that’s configured correctly and gets popped, half the Internet is already a wasteland.
If you’re running containers, yeah technically there are escape vectors, but again your attacker would need to pop the proxy software. It’d probably be way easier to go after the apps themselves.
Do something like this with NICs on each subnet:
DMZ VLAN <-> Proxy <-> Services VLAN
Right, I could have been more precise. I’m talking about security risk, not resilience or uptime.
“It’ll probably be the most secure component in your stack.” That is a fair point.
So, one port-forward to the proxy, and the proxy reaching into both VLANs as required, is what you’re saying. Thanks for the help!
It depends on the trade-offs you want to make. If you want to maintain one less Nginx install with a little more risk, that’s a way to go.
If your priority is security, use a separate proxy for your private services and do allow your public VLAN access into your private VLAN.
My home network only has public services on it right now, but now you are making me think I should segment it further if I want to host any truly private services there.
The answer seems to always be “not segmented enough”. ;)
Plus, the internal and external services are running on the same box. Is that where my real problem lies?
It’s one of them, yes.
If you want to limit exposure in the case of a compromise you need to put everything public facing in it’s own vlan that cannot initiate traffic into your lan.
Haha, why do I even ask.
