Hey guys i cant find any usefull guide on how USB c charging works in depth. In particular i have bought a pair of Sony headphones which i would like to make wireless change so I also bought a crappy wireless coil meant to convert a phone into wireless charging. i opened the headphones, located the ground and 5v pin coming from the USB connected the circuit and surprise the charging led doesn’t light … The charging board is separated from the main board so I checked the flat cable that connects them, found the 5v and gnd ,spliced into it, and the led light lit as if it was charging. the next morning the led was of signaling the headphones are full, unfortunately after powering them on the battery status indicated was still 20% as the evening before … Have I done anything wrong ? What about that phase when they negotiate the power output with a magic resistor ? What should I try next? Thanks in advance 👍🏻

  • TechNerdWizard42@lemmy.world
    link
    fedilink
    English
    arrow-up
    2
    ·
    7 months ago

    You generally can’t just connect two power supplies together. Usually you’ll want some sort of power path style controller.

    You’d want to check the output with an oscilloscope.

    • DNOS@lemmy.mlOP
      link
      fedilink
      English
      arrow-up
      1
      ·
      7 months ago

      Thanks i Will make sure to connect only One at a time … 👍🏻

      • TechNerdWizard42@lemmy.world
        link
        fedilink
        English
        arrow-up
        2
        ·
        edit-2
        7 months ago

        Cheap power supplies being back-powered from the output will die. By connect together I mean put in the same circuit. Not use at the same time.

        You’re possibly powering the other power supply through the feedback resistors, ESD diodes, etc. You really want a controller that can share between the two sources or just 2 diodes if you can take the voltage drop

        • DNOS@lemmy.mlOP
          link
          fedilink
          English
          arrow-up
          1
          ·
          7 months ago

          Oh now its clear i dont have a special controller neither the space to fit It inside the headphones so i will go the diode rout, if i pay attention not to plug them both in at the same time could I use only one for the wireless circuit ? How do I know if I can take the voltage drop ?