Manufacturer wanted $25 (+shipping) for a replacement garage door opener wall switch. 13 minutes of printing + 5 minutes of soldering + two leftover Cherry MX Blue switches (that I’ll be use) and the problem is solved 👍

Note: The wiring was slightly more involved than I thought… needed a resistor for the light (there’s only two wires but it’s got two functions: Light on/off and garage open/close.

If folks are interested I could make a much fancier PCB-based version with screw terminals and whatnot. It’s a very trivial schematic.

  • TheFlame@lemmy.world
    link
    fedilink
    English
    arrow-up
    0
    ·
    1 year ago

    This is so stupid, but I love it so much. 🤣 I’m tempted to give it a try, but I’m worried that once I get used to mechanical switches on my garage door opener - I’ll need them throughout the rest of the house too.

    • Riskable@programming.devOP
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      Do it! Normal garage door openers are good for like 1,000 cycles (if that, haha). With these switches it should be good for 50 million.