You must log in or # to comment.
This isn’t a very good guide. There are a bunch of gottas for Proxmox and I am sure it is the same deal for XCP-NG.
Here is the official Proxmox docs:
https://pve.proxmox.com/wiki/PCI(e)_Passthrough
For adding modules I personally had to switch to grub. You can switch over with Proxmox boot tool.
I’m going through it rn for Proxmox, it’s a pain in the ass.
I think it was better a tad on ESXi, but VMware stuff is a non starter for me at this point.
In Proxmox VE 8 it was a one click once I enabled IOMMU. Before it required manually copying firmware and editing files.
I can really recommend XCP-ng. For me it strikes a pretty good balance of features and ease of use.
